BEFORE YOU BEGIN:

1) This product is specifically designed for set up on the outside of the vehicle.

2) Required Items embody an installation squeegee, masking tape, glass cleaner, dry paper towels, measuring tape or ruler.

three) Do not apply any vinyl graphics in direct sunlight. Make certain it is between 60 degrees and eighty degrees F. Park the vehicle within the garage in the shade. Let cool for 30 minutes if hot.

4) Do not store unapplied graphics in direct sunlight – damage could occur.

5) All filth, grease and wax must be removed from the automobile surface earlier than the decal is applied. This contains wax from mechanical car washes, rain-x, compound, etc. Failure to take this step might outcome in the decal not sticking to the vehicle surface.

STEP 1 – UNPACK THE SHIPPING CONTAINER – Remove decals from packaging. Lay decals flat on a smooth table in an area that is not less than 60° F and below eighty° F.

STEP 2 – PREPARE THE SURFACE – An important step throughout decal installation is making positive the set up area is clean and dry. Make positive there may be NO WAX, RAIN-X, COMPOUND, lint, dust, or different residue on the surface. Remove all wax, compound residue, automobile wash protestants, etc with rubbing or denatured alcohol. After cleaning the surface, go over the surface with regular glass cleaner.

STEP 3 – FIND DESIRED LOCATION OF THE STRIPES – Utilizing a string or different line, place it over the vehicle from the entrance to the back within the desired location for the stripes. Make certain that the string is symmetrically centered on the vehicle. Mark this location with a pencil of other nonpermanent marking device at the entrance and the rear of each body panel. This will function the situation of the sting of the stripes.

STEP 4 – PLACE THE STRIPES – Measure the length of each body panel to which the stripe is to be applied. Lay the stripe part over the area of the vehicle, trimming the surplus stripe off one end (depart at least an inch additional) Save all reduce off pieces, as they can be utilized to cover bumpers and fins.

STEP 5 – SECURE THE STRIPES – Place a strip of masking tape at one finish of the stripe, as this will hold the tip of the stripe while installing. Working from that end to the other, slowly peel back the discharge paper half way down and spray the body surface with a fine mist of water resolution (not soapy solution). With a squeegee, apply the stripe to the body panel working from the center of the stripe outward. As you work additional down the stripe, slowly proceed to remove the backing paper as needed. Slowly continue to apply the stripe with the squeegee, applying even pressure throughout the width of the stripe.

STEP 6 – REMOVE THE TRANSFER PAPER – As soon as the whole piece is applied, remove the masking tape from the top of the stripe. Next remove the switch tape covering, caretotally pulling parallel to the surface of the vehicle (NOT UP BUT SIDEWAYS).

STEP 7 – FINISH INSTALLATION – Any small air pockets may be easily removed by first placing a small hole within the bubble (small gap, not large slice). Then moisten the squeegee edge with water and slide the squeegee alongside the surface of the stripe the place the bubble is, working the air towards the hole.

CARE AND MAINTENANCE:

As soon as the decal is put in, to keep it looking new, merely wash it whenever you wash the vehicle. You possibly can apply car wax, clearcoat, or RainEx over the decal as soon as it is applied. your new decal provides you with years of great looks. In case you are in cold climate be careful when using an ice scraper on any surface the place decals are applied.

In case you have just about any questions relating to where by in addition to how you can use custom car decals, you’ll be able to e mail us on the internet site.